Length | x | Width | x | Height | Weight approx. |
1600mm | x | 820mm | x | 1450 mm | 425 kg |
壓縮機主要功能：
1. 七寸彩色觸摸式顯示屏，西門子PLC控制系統，德國威卡壓力傳感器
2. 帶入口壓力監控、油壓監控、級間壓力監控、系統壓力監控
3. 帶ACD自動排污系統
4. 自動啟停機功能，入口進氣壓力低報警
5. 安裝隔音外殼
6. 帶維修保養周期提醒
Technical Data for Compressor Block:
壓縮機主機技術參數：
Medium : 壓縮介質 | 空氣/氮氣 |
Intake Temperature : 進氣溫度 | +5 to +45°C |
Ambient Temperature : 環境溫度 | +5 to +45°C |
Nominal Pressure Max. : 安全閥壓力 | 330bar |
Working Pressure : 工作壓力 | 300 bar |
Capacity : 流量 | 250 l/min |
Number of Compression stages : 壓縮級數 | 3 |
Number of Cylinders : 汽缸數 | 3 |
Stroke : 活塞沖程 | 40 mm |
Drive : 驅動方式 | 皮帶 |
Technical Data for Prime Mover:
驅動電機的技術參數：
Type : 型號 | three phase electric motor |
Power : 功率 | 5.5 kW |
Speed : 轉速 | 2840 1/min |
Voltage : 電壓 | 380 v |
Frequency : 頻率 | 50 Hz |
Standard Scope of Supply:
供貨范圍
COMPRESSORBLOCK
壓縮機主機
Oil pump for force feed lubrication with oil filter
油泵帶油濾器作注油式潤滑
Oil sump content: 2,8l
主機的油池容量：2.8升
Interstage coolers, air cooled after each stage
每級壓縮后都設有冷卻器 (風冷)
Aftercooler, air cooled, outlet temp. approx. 10-15 °C above ambient temp.
壓縮氣體經過冷卻器后的溫度大約高于環境溫度10-15 °C
Intermediate oil/water separators after each stage (exept 1st stage)
每級壓縮后都設有中級水油分離器 (除級外)
Final oil/water separator
終級水油分離器
Safety valves after each stage
每級壓縮后都設有安全閥
Final pressure safety valve
終級安全閥
Pressure maintaining and check valve before compressor outlet
壓縮機出口前設有壓力維持閥及單向閥
Crankcase venting back to suction side
曲軸箱排放到冷凝水收集器
Final pressure gauge
終級壓力表
First oil filling
壓縮機已加注潤滑油
BAUER 德國原裝高壓重載主機
油泵強制潤滑，滿足7天*24小時重載運行
AUTOMATIC CONDENSATE DRAIN DEVICE
冷凝水自動排放器
Drains all oil/water separators during compressor operation
在壓縮機運作過程中會排放所有水油分離器的冷凝水
Draining interval is adjustable
可調整每次排放間隔時間
Unloaded start integrated (automatic drain during shut-down of the unit)
不負載起動 (冷凝水會自動排放當壓縮機關掉時)
Condensate collecting tank 10l with silencer and filter for exhaust gas
排氣設有消音器及過濾器的10升收集箱
CONFIGURATION AND STYLE OF UNIT
壓縮機構造及款式
Horizontal arrangement of the unit on solid crash frame
壓縮機水平安裝在穩固底架上
Shock absorbers for free standing installation
設有減震器的獨立式設置
Instrument panel and monitoring elements integrated in compressor frame
儀表板及監控原件裝在壓縮機架上
High pressure outlet: ：fitting 8S for pipe ? 8mm
高壓出口: 8mm卡套接頭（適合8毫米外徑鋼管）
COMPRESSOR CONTROL
壓氣機自動控制箱
For automatic shut down at final pressure
全自動化啟停機根據終端壓力
